Rustic Cabin Decor: Birch Branch Cork Board Project

Rustic Cabin Decor Craft Project

This simple Rustic Cabin Décor Birch Branch corkboard craft project is a great way to make a rustic cabin inspired project for the wall. Whether you live in a cabin or not, this is a fun rustic look that would work well in almost any room in the house from the kitchen to the family room to a child's bedroom.

This simple Birch Branch corkboard is perfect for a child's room or even a Rustic Cabin Décor home office. You can hang it over the desk a have something to look at while that reminds you of nature while you work!

You can make this Rustic Cabin Décor Birch Branch cork board for about $40 or less. You can make it for a lot less if you already have some Birch Branches you don't mind drilling a hole in.

To make a Birch Branch Cork Board You Will Need:

4 Birch Branches

Power Drill

½ inch drill bit

Sheet of pine Plywood

Sheet or roll of corkboard

Spray Adhesive

Scissors or exacto knife

Tape measure

Twine or leather shoe laces

Now, the first set is to measure how long your Birch Branch is. You and do this simple Rustic Cabin Décor project with any sized Birch Branch. If you can not find any birch branches if you do not have a yard, then try checking out your local plant nurseries. They may have sources for buying some of this beautiful and unique wood!

Now, have you sheet of plywood cut into a square that is about three inches linger and wider than your Birch Branch are long. So, if your Birch Branch is 30 inches long, then you will want your plywood square to be 33 inches by 33 inches.

Now, cut out your sheet for corkboard to 33 inches by 33 inches, or whatever sizes your plywood square is.

If you have any leftover corkboard, then you can cut strips to glue onto the edge of your plywood board. Just measure the length and width, cut the corkboard and glue with the following directions.

Now, lay you sheet of cork board out on a flat surface. Lightly spray it with a good quality spray adhesive, the kind that come in an aerosol can. You could also use a wood glue if you want.

Now, place your corkboard on the plywood sheet. Line the edge up and press it into place.