The First Step Towards Preparing Your Tabletop Miniatures for Battle/Showcase
corey walden
- Published Content: 19
- Total Views: 1,439
- Favorited By: 2 CPs
There are hundreds of thousands of hobby shops out there, and millions of corresponding hobby games enthusiasts. A lot of us play tabletop war games, with numerous detailed plastic and metal miniatures. Nothing looks better than a well-painted and modeled army at the end of the day, so I'm here to h 
elp the rest of you achieve this goal.
The first step is removing the models from any sprues they came attached to. This should be done carefully with pliers or a hobby knife, making sure not to accidentally cut through the plastic with a dull blade and damage the miniatures or hurt your self. A sharp blade is best. This is best done over a desk or table with a cutting pad where pieces cut off wont get lost if they shoot off of the sprue, and your knife wont cut the surface you're on.
The next step is to use your hobby knife once again, along with a modeling file (similar to a nail file but a heavier duty metal one specifically for hobbyists and model builders) and use these to remove the blast and molding lines still present on your miniatures. Depending on the quality of the molding by the manufacturer there may be a lot or a little of this excess debris. This must be done slowly and carefully, as it is very easy to have your knife or file slip and take some of the surface of your miniature with it, causing scarring and damage you did not intend.
Again, depending on the quality of the manufacturing you may want to wash and scrub your newly cut miniatures with soap to remove any extra plastic or metal particles from the surfaces. If there is a considerable amount of extra plastic or metal dust on the surface paint will not stick, or will look blotchy and rough when painted. Most miniatures don't need this, but it is a good precaution to make sure your models come out looking as best as possible. Professionals don't paint a miniature without this step.
The first step is removing the models from any sprues they came attached to. This should be done carefully with pliers or a hobby knife, making sure not to accidentally cut through the plastic with a dull blade and damage the miniatures or hurt your self. A sharp blade is best. This is best done over a desk or table with a cutting pad where pieces cut off wont get lost if they shoot off of the sprue, and your knife wont cut the surface you're on.
The next step is to use your hobby knife once again, along with a modeling file (similar to a nail file but a heavier duty metal one specifically for hobbyists and model builders) and use these to remove the blast and molding lines still present on your miniatures. Depending on the quality of the molding by the manufacturer there may be a lot or a little of this excess debris. This must be done slowly and carefully, as it is very easy to have your knife or file slip and take some of the surface of your miniature with it, causing scarring and damage you did not intend.
Again, depending on the quality of the manufacturing you may want to wash and scrub your newly cut miniatures with soap to remove any extra plastic or metal particles from the surfaces. If there is a considerable amount of extra plastic or metal dust on the surface paint will not stick, or will look blotchy and rough when painted. Most miniatures don't need this, but it is a good precaution to make sure your models come out looking as best as possible. Professionals don't paint a miniature without this step.