Pizza Slice: The Ultimate DIY Halloween Costume

Materials Needed:
- 2 Large Pieces of White Foam Board (This can be found at any craft store. Sometimes, you may be able to find it at a store such as Wal-Mart or Target.)

- 1 Bottle of Red Craft Paint (This can also be found at any craft store or Wal-Mart/K-Mart/Target. If you're unsure as to what brand to buy, ask a store associate for the best brand of paint for the Foam Board surface. Also, you'll find better results with a darker shade of red.)

- 1 Can Artifical Snow (This can be found at any Wal-Mart/K-Mart/Target. Check their stock, however, some stores do not sell this product year round.)

- 1 Roll Duct Tape (This can be found at any local hardware store, Wal-Mart, Target, etc.)

- 1 Bottle Elmer's Glue (This can be found at any local craft store, CVS, Walgreens, Wal-Mart, etc.)

- 1 Roll of 2in. Thick Red Felt Ribbon (This can be found at any local craft store, Wal-Mart, K-Mart, or Target.)

- 3 Sheets of Red Felt (This can be found at any craft store, Wal-Mart, Target, K-Mart, etc.)

- A Pair of Red Sweatpants and a Red Sweatshirt (This can be found at any local clothing store. It's cheapest at places like Wal-Mart, Target, K-Mart, and Forman Mills.)

- Small Container of Red Face Paint (This can be found at any local costume store, Wal-Mart, K-Mart, Target, etc.)

- Pencil

- Ruler (Or anything with a straight edge.)

- Sharp Knife (Or any instrument that's sharp. This will be used to cut your foam board. Keep in mind that you will be cutting both boards at one time.)

- Scissors

- Paintbrush

Instructions:
1.) Take the two large pieces of foam board and lay them over top of each other. With your pencil, make a small mark directly in the middle on the very bottom of the foam board.

2.) Using your ruler, make very light lines from the top corners of your foam board to the mark you previously made in step one.

3.) Take your knife (or other instrument) and cut both pieces of foam board along the lines you made in step two. After you have both pieces of foam board cut, discard the smaller pieces and set one piece of the foam board aside for later.