How to Replace a Ceiling Tile

By Amy Whittle, published May 06, 2008
Published Content: 374  Total Views: 406,888  Favorited By: 6 CPs
Rating: 3.0 of 5
Acoustical ceiling tiles are often difficult to replace because of the grooves that are used to fit each individual tile together. This makes replacing a single ceiling tile a more difficult job than replacing a floor tile. However, once you know how to repair a ceiling tile it is an easy job, even for an inexperienced homeowner.

Water damage is a common problem with acoustical ceiling tiles. Before replacing them, it is important to make sure that there is no other damage to your ceiling. Be sure to check the surrounding furring strips and any insulation for signs of rot or mildew. The area should also be completely dry before replacing the ceiling tiles. To help facilitate drying, you may remove the damaged pieces and then allow the area to dry before completing the job.

Begin by removing the damaged tiles. Because the ceiling tiles interlock, you should be aware that you must start by cutting each ceiling tile you wish to remove into pieces. Then you can remove all of the individual pieces by pulling towards the center of the tile and dislodging them from the edges.

If you are only removing and replacing a single tile, then you should then remove the back of the groove of the tile to make it easier to install. Do this step using a metal straight edge and a sharp utility knife. Sometimes removing a tongue of the replacement piece is also necessary, so you can ease the ceiling tile into the space allowed for it. Does a test fit for the altered piece. If it fits well, put some construction adhesive on the furring strips that were exposed when you removed the damaged pieces and press the replacement into place.

If multiple tiles must be replaced the process is slightly more complicated. Once the damaged pieces have been removed, you must then plan how you will replace that section. The easiest way is to use construction adhesive on the furring strips that will come into contact with the first ceiling tile you will replace. Then you should slide the piece into place, without cutting off any of the back tongue and grooves.

Did You Know?
There are a variety of ceiling tiles that are stain resistant and water resistant. Consider them for a ceiling that is located in a bathroom or kitchen.
Comments
Type in Your Comments Below
Your name:

Submit your own content on this or any topic. Get started »
Most Commented On