How to Remove an Old Stainless-Steel Kitchen Sink
Part One: Replacing a Stainless-Steel Kitchen Sink
By Eric Brennan, published May 29, 2008
Published Content: 153 Total Views: 353,487 Favorited By: 5 CPs
Embed:
Stainless-steel sinks have not been around forever. Back then, it was porcelain-coated cast iron. Although they were beautiful, heavy use would cause the porcelain to chip and then rust the iron underneath. Stainless steel was invented in 1913 by a gunsmith named Harry Brearly who worked for British Steel Corp. He experimented with creating stronger steel by adding chromium to the steel. While it added to the strength, he also noted it provided less corrosion because his gun barrels didn't rust. It was later strengthened with nickel, which is very close to the modern day stainless steel we have in modern times.Sinks are the most important part of any kitchen, especially a stainless-steel sink. They do tend to get grubby with age from physical wear and tear. But no matter how hard we try to keep them clean, they will age and they occasionally need to be replaced. It's a fairly easy job; you just need a few tools and a little time.
The first thing you need is a cordless screw gun with a Phillips head bit. You want to remove the doors of the cabinet underneath the sink to provide enough room to work comfortably. Keep the screws together on the same hinge with a little tape. You do not want to mix them up because it might cause the doors to change swing slightly.
Next, you need to disconnect the water supply lines and the waste line. First, shut off the water supply valve. Most kitchen sinks have valves underneath to shut off the hot and cold. If you do not have these oval shaped valves under your sink, then find the shut off valve for your house. Next, turn on the faucet and let any water left in the line drain out. Turn the faucet off. Place a bucket underneath the sink before you disconnect and water or drain lines. Use an adjustable wrench to disconnect the water supply lines from the bottom of the faucet. Now, place the bucket under the drain trap and loosen the slip nuts off the drains tailpiece and back of the trap. Careful, don't get any water on you or your cabinet!
You may also like...
- Ways to Brighten Up Your Kitchen
- Decorative Ideas for Your Kitchen
- Clogged Sink? the Secret to Civilized Si...
- Why You Should Always Call a Professiona...
- The Pros and Cons to Having One Large Si...
- Your Favorite Food Brands Become Fabulou...
- How to Unclog a Sink
- Cleaning Your Kitchen Using Household It...
- The Pros and Cons to Having Two Kitchen ...
- Restore Your Stainless Sink to New and S...
Takeaways
- Stainless steel sinks come in a variety of thickness ranging from 18 gauge to 23 gauge.
- Stainless steel isn't your only option. There are porcelain, plastic, granite and fiberglass.
- Don't forget to turn off the water supply first!
Did You Know?
Stainless steel was invented in 1913.
Comments
Type in Your Comments Below - (1000 characters left)
Most Commented On
