How to Install a Pet Door

If you have a pet that likes to go in and out of the house more than you like to get up and down to allow it, or you simply would like to create an easy way for your pet to allow himself in and out of the house at will, installing a pet door is just the solution. Of course you can create interior pet doors as well with this guide, depending on your preference.

First of all you will need to measure the largest pet that will be using the door so you know the appropriate sized door kit to purchase. You want the door to be very slightly larger and wider than your pet's measurements. Now it is time to gather your supplies. You will need the following:

A pet door kit

Safety Glasses

Measuring tape

Drill and drill bits

Jig Saw

Pencil

Masking Tape

Caulk

In the pet door kit you will find a template for marking cut holes on your door. Use that to find the spot you would like your pet door to be. Use the tape measure to ensure you have it evenly spaced on all sides. You also need to make sure that you have it spaced approximately four inches from the bottom of the door or more (depending on the size of your pet). If you cut any lower than that you could very easily compromise the sturdiness of the door. Use your masking tape to put the template in place when you have decided where it will go. Measure again for accuracy on where it is placed. When you are sure that it is where you would like it to be, mark the holes with a pencil to denote where you will be drilling and use your pencil to trace the outline of it. You can then remove the template from the door.

Use your drill to make holes where you have marked them with the pencil. You also want to use it to make a slot big enough for your jig saw to fit into. Put your safety glasses on and then use your jig saw to cut out the space inside of the outline you have made. Be careful to wear your safety glasses to avoid splinters or shards of wood from getting into the delicate eye area.